Update on progress.
All crossovers are tested, soldered, mounted, and wired. Wiring actually takes a bit of time.
All boxes have foam spray glued on all inside surfaces. ( I have used just about every 3M spray glue but I think I like the headliner glue the best. Time to stick and nozzle wise.)
All boxes are glued except for one face.
Finish Living Room wall:
-Install corner bead on center hole.
-Finish interior portion of hole
-Create new aluminium frame based on Michael Hurds suggestions. (1099 Hole will be smaller after flat edges are final)
-Install black speaker grill fabric around aluminum frame
-Install Neodymium magnets on frame and wall
-Glue on last top
-Prep all surfaces (Sand flat, clean)
-Install Wilsonart Matte Black laminate on every surface but front.
-Install Wilsonart Brighton Walnut laminate on front of all three 1099s.
-Install components. (Can't wait!!!)
Is it bad that I want Christmas to be over so I can get back to work?!
Sent from my Pixel 3 using Tapatalk